Review ID: 67586

Review Text: Solid enthusiast case. I bought this case on a bit of a whim with no research, making a last-second decision to build a new PC rather than just upgrade my old one. I don't regret it at all. The mesh front, 3 included fans, removable dust filters in front, on top, and even on the bottom below the PSU make for a great value as far as airflow goes. The top of the case doesn't leave much room for radiators, so they'll either have to go in front (up to 360mm) or in the back (for a single 120mm) if you plan on water cooling. The PSU shroud with removable drive bays and rubber grommets in the motherboard tray (and PSU shroud!) make cable management somewhat manageable. There isn't much room behind the tray, especially if you're using a non-modular PSU, but it's not hard to make it work. The SATA/USB powered/controlled fan hub does wonders for cable management (especially if you subscribe to the "just shove them somewhere out of sight" school of thought, as I do). The front IO has 2 USB 3 ports and a single combined 3.5mm mic/out rather than separate in and out, a power button, and reset button. The rear of the case doesn't support vertical mounting of GPUs, so keep that in mind if you're planning on showing off your build. The front panel pops off with ease, making it super simple to clean out the dust filter, and the magnetic filter on top is almost too easy to remove, but I'm not complaining. The tempered glass panel is attached with 4 thumbscrews with felt backing. I never felt like I was going to crack the glass by over-tightening, and the 1" bezel on the back of the glass is great if you plan on running RGB strips inside without having to see the christmas light effect. The feet on the case are only about 1/2" tall, which might affect airflow if you're mounting your PSU fan-down, so I wouldn't advise putting this down on carpet (not that you should anyway, that's just asking for dust). If you're not planning on water cooling, this is a solid ATX/Micro ATX case.

Gold Attribute: {'Motherboard Form Factor': 'atx', 'USB Port Location': 'front', 'Window Panel(s)': 'front', 'Color Category': 'black', 'Color': 'black'}

Review Image:

1. 
2.